Gladiator GAJG36FDZW Instruction Manual download pdf (Page 4)

6. Using the hex key (provided), completely tighten all 28 cabinet

bolts and nuts.

Install Leveling Legs

(optional)

IMPORTANT: If you are going to install the cabinet on Gladiator

GearWall

panels or GearTrack

channels, you do not need to install

leveling legs.

1. Place the cabinet on its side.

2. Screw a leveling leg (P4) into each of the four rivet nuts located at

the corners of the cabinet as shown.

3. Stand the cabinet upright.

4. If you have not already done so, fasten the two bolts at each

front corner, of the cabinet frame. Completely tighten all of the

cabinet bolts and nuts.

Install Shelves

IMPORTANT:

■ Use the pair of slots located in the middle of the cabinet sides to

install a center shelf (P5ml). The magnet should be on the left-

hand side and facing out when installed, so that the door closure

will make contact with the shelf, and the door will lock. The other

two shelves may be installed where desired.

■ The shelves are supported by the metal slots on the cabinet

sides.

■ Make sure that the shelf (P5ml) magnet is visible on the

left-hand side and facing out as shown below.

1. Place a shelf (P5ml) so that the two tabs in the shelf ends are

aligned with the pair of slots in the middle of the cabinet sides.

2. Tilt the shelf so that one end is higher than the other as shown.

A. Leveling legs

AAA

BBB

CCC

DDD

EEE

A. Middle pair of slots in cabinet side

A. Push down.

B. Lift up.

P5ml

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Gladiator GAJG36FDZW Instruction Manual Page 4