Gladiator GAJG36FDZW Instruction Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
5
3. Insert the shelf into the cabinet so that the higher end is directly
above the desired slots and push the shelf down into place
behind the side slots. Raise the lower end so it is directly above
the desired slots and push the shelf down.
NOTE: You may need to slightly bend the shelf tabs outward for
the tabs to engage in the slots. Make sure the shelf tabs are in
place behind all the slots, as shown.
4. Repeat steps 2 and 3 for the remaining two shelves (P5mr). The
magnet for shelves (P5mr) is located on the right-hand side and
facing out as shown below.
NOTE: Make sure the magnet in the right of each long shelf
edge, is facing outward.
Adjust the Shelves
1. Lift up on the underside of the shelf until the shelf tabs are free of
the cabinet slots.
2. Tilt the shelf up to reposition it within the cabinet or to remove it
from the cabinet.
Install Doors
IMPORTANT:
The door with the lock assembly (P7) should be installed on the
right-hand side of the cabinet.
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are
fastening the screws.
1. Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle four screws through the door hinge into the
cabinet and hand tighten.
INSTALLATION INSTRUCTIONS
IMPORTANT:
Gladiator brand Premier Jumbo cabinet is designed to be
installed on Gladiator
®
GearWall
®
panels or GearTrack
®
channels.
If GearTrack
®
channels will be used to support the Gladiator
®
Premier Jumbo GearBox cabinet, you must use three channels
installed 18" (45.72 cm) apart.
Be sure the GearWall
®
panels or GearTrack
®
channels are
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
A. Cabinet slot
B. Shelf tab
A. Magnet facing outward
A
B
P1
P1
P2
P3
P5mr
P5ml
P5mr
A
F3c
Phillips-head screw (12)
A. Phillips-head screws
P1
P2
P5mr
P5ml
P5mr
P3
P7
A
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
18" (46 cm)
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments