Gladiator GAJG36GRDG Instruction Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
4. Repeat steps 2 and 3.
NOTE: Make sure the magnet in the right of each long shelf edge
is facing out.
Adjust the Shelves
1. Lift up on the underside of the shelf until the shelf tabs are free of
the cabinet slots.
2. Tilt the shelf up to reposition it within the cabinet or to remove it
from the cabinet.
Install Doors
IMPORTANT:
The door with the lock assembly (P7) should be installed on the
right-hand side of the cabinet.
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are
fastening the screws.
1. Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle 4 screws through the door hinge into the
cabinet and hand tighten.
4. Repeat steps 2 and 3 to attach the left-hand door (P6).
5. Align the doors and completely tighten the door screws.
Complete Assembly
1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling legs. Turn to the
left to raise or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the
door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.
ACCESSORIES
To order accessories, call 1-866-342-4089 and ask for the accessory
part number listed below or contact your authorized Gladiator
®
GarageWorks dealer. In Canada, call 1-800-807-6777.
Mounting Bracket Kit - Allows the cabinet to be mounted on
Gladiator
®
Garageworks GearWall
®
panels or GearTrack
®
channels.
Order Part # GABK362PSS
A. Magnet facing outward
F3c
Phillips-head screw (12)
P1
P1
P2
P3
P5mr
A
P5mr
A. Phillips-head screws
P1
P2
P5mr
P5mr
P3
P7
A
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments